Mellerware Carpet Cleaner 23810 User Manual

E X E C U T I V E  
BRAVIS SIMO II PRO - STEAM STATION  
complies with  
INTERNATIONAL  
Model:  
2 3 8 1 0  
IEC60355  
2100W  
SAFETY SPECIFICATIONS  
PLEASE READ ALL INSTRUCTIONS BEFORE USE  
2 y e a r g u a r a n t e e  
 
MW_EX_23810_BRAVISSIMO_PRO 2_IM.indd 1  
11/17/2009 12:49:20 PM  
Fig. 1  
Fig. 2  
Fig. 3  
Fig. 4  
Fig. 6  
Fig. 5  
 
MW_EX_23810_BRAVISSIMO_PRO 2_IM.indd 3  
11/17/2009 12:49:22 PM  
Tips and safety warnings  
- Do not use the appliance if it has been dropped,  
if there are visible signs of damage or if it leaks.  
-This appliance is not intended for use by  
persons(including children)with reduced physi-  
cal, sensory or mental capabilities, or lack of ex-  
perience and knowledge, unless they have been  
given supervision or instruction concerning use  
of the appliance by a person responsible for their  
safety.  
Before using the appliance for the first time  
This professional iron works with tap water.  
However, the use of distilled water is recomended  
in areas with a high lime level in the water. Some  
parts of the iron have been slightly greased.  
They can therefore give off steam on first use, but  
this steam will disappear after a short time.  
-Children should be supervised to ensure that they  
do not play with the appliance.  
-Please read these instructions carefully before us-  
ing the appliance and keep them for future refer-  
ence.  
Practical tips  
-Unpack the appliance and check it is in perfect  
condition and working order, as any factory fault  
or damage caused by transport is covered by the  
MELLERWARE guarantee.  
-Keep the sole plate smooth, do not apply it to  
metallic objects (i.e., to the ironing-board, butons,  
zips...).  
-Fit the iron in its housing (L) for transport and stor-  
age, in order to improve its stability.  
-To avoid burns, do not lean Bravissimo 2 Pro’s  
iron on its back.  
-This device has been designed for household  
use, not for commercial use.  
-Do not leave the appliance without supervision if  
you are not going to use it immediately. This will  
save energy and prolong the working life of the  
appliance.  
Steam ironing  
-Keep the appliance out of the reach of children.  
-The appliance must not be connected to the  
mains while the boiler is being filled (Fig. 1).  
-Before connecting the appliance to the mains, en-  
sure the supply voltage is the same as that marked  
on the appliance. The water filling inlet must not  
be open during operation.  
When you start to iron, proceed as follows:  
-Unscrew the cap (F) and fill the boiler with water,  
using a jug (Fig. 1) (if you fill it with hot water, the  
appliance will be ready for use sooner).  
-Even if the boiler has a certain level of water, it is  
always recommended to fill it to the top for a longer  
range, thanks to its large 1l capacity.  
-This appliance must be connected to an electrical  
socket with an earth connection.  
-Carefully close the cap (F), screwing it to the end.  
-Place the boiler on a flat , stable surface.  
-Plug the appliance into the mains.  
-Any improper use or failure to comply with the in-  
structions for use will invalidate the warranty and  
free the manufacturer from any liability  
concerning the appliance.  
-Switch on the boiler and the iron by pressing the  
relevant switches (B) and (A). The corresponding  
LEDs will light (Fig. 2).  
-IF THE IRON IS IN ITS HOUSING AT MAXIMUM  
TEMPERATURE FOR A LONG TIME, IT MAY DIS-  
COLOUR, BUT THIS HAS NO EFFECT ON THE  
PROPER OPERATION OF THE APPLIANCE.  
- The appliance must be used and placed on a flat,  
stable surface  
- When placing the appliance on its support, make  
sure the surface on which the support is fitted is  
stable.  
 
MW_EX_23810_BRAVISSIMO_PRO 2_IM.indd 4  
11/17/2009 12:49:22 PM  
Important: For cotton and linen clothes, it is rec-  
ommended to put the base of the iron in contact  
with the fabric. For more delicate fabrics, it is rec-  
ommended to keep the base of the iron at a dis-  
tance of some centimetres.  
Thermostat  
control  
Type of  
fabric  
Steam  
position  
No  
No  
Nylon / Silk  
Wool  
••  
Yes  
Cotton, Linen  
Dry ironing  
•••  
-Connect the professional iron to the  
mains.  
It is recommended not to use steam in the • and  
•• thermostat positions, as water could drip.  
-Turn on the iron switch (A).  
-Set the iron temperature with the thermostat con-  
trol (J), depending on the fabric to be ironed.  
-Set the desired temperature with the thermostat  
control (J), depending on the type of cloth to be  
ironed (Fig. 3).  
After each ironing  
-The appliance will be ready for use when the  
pressure indicator LED (E) lights up (Fig. 4).  
While ironing, this LED (E) goes on and off auto-  
matically, this is normal.  
-Switch off the professional iron by pressing  
switches (B) and (A).  
-Unplug the power cable (G) from the mains.  
-Clean the base of the iron while it is still hot,  
using a damp cloth, after each use.  
-The rest of the appliance can also be cleaned us-  
ing a damp cloth.  
-By pressing the steam switch (H) you will get a  
constant steam jet (Fig. 5). The steam stops when  
you release the switch.  
Never submerge the appliance in water or any  
other liquid, or hold it under a running tap. Do  
not use solvents or abrasive products to clean  
it.  
How to fill the boiler while ironing  
To fill the boiler, proceed as follows:  
-Eliminate steam pressure from inside the boiler  
by switching on the steam switch (H) (Fig. 5).  
-Turn off the boiler (B) and iron (A) switches.  
-Unplug the appliance from the mains.  
-Carefully unscrew the cap (F) to let the residual  
steam out of the boiler.  
Maintenance  
With the boiler’s descaling system, limescale in-  
crustations are reduced thanks to the exclusive  
features of the stainless material used. To clean the  
inside of the boiler, you simply have to proceed as  
follows every three months:  
-Wait for some minutes and carefully pour 1l of  
water into the boiler using a jug (Fig. 1).  
-Carefully close the cap (F) again, screwing it to  
the end.  
Fill the boiler with tap water, shake and empty. Re-  
peat these steps two or three times consecutively.  
Vertical ironing  
To descale:  
-Unplug. Empty the content of a bag into the boiler.  
Fill with water and select the steam position.  
-Plug in. Switch the professional iron on.  
-Place the iron in the ironing position. Activate the  
steam, shake the iron softly.  
It is possible to iron hanging curtains, garments  
on their own hangers... (Fig.6)  
-Adjust the iron thermostat control (J) to the maxi-  
mum temperature.  
-Iron from top to bottom and press the iron steam  
switch (H).  
-Let the product work for 10 minutes.  
-Rinse thoroughly with water & empty completely.  
 
MW_EX_23810_BRAVISSIMO_PRO 2_IM.indd 5  
11/17/2009 12:49:22 PM  
Breakdowns and repairs  
Breakdowns and repairs  
In the event of any breakdown, check the follow-  
ing chart.  
In the event of any breakdown, check the follow-  
ing chart.  
- In the event of malfunctions, take the appliance to  
an authorized Technical Support Service.  
- Do not try to dismantle or repair it yourself as this  
may be dangerous.  
- In the event of malfunctions, take the appliance to  
an authorized Technical Support Service.  
- Do not try to dismantle or repair it yourself as this  
may be dangerous.  
- If the mains connection is to be replaced, pro-  
ceed as in the event of a malfunction.  
- If the mains connection is to be replaced, pro-  
ceed as in the event of a malfunction.  
After each ironing  
-Switch off the professional iron by pressing  
switches (B) and (A).  
-Unplug the power cable (G) from the mains.  
-Clean the base of the iron while it is still hot,  
using a damp cloth, after each use.  
-The rest of the appliance can also be cleaned us-  
ing a damp cloth.  
Never submerge the appliance in water or any  
other liquid, or hold it under a running tap. Do  
not use solvents or abrasive products to clean  
it.  
Maintenance  
With the boiler’s descaling system, limescale in-  
crustations are reduced thanks to the exclusive  
features of the stainless material used. To clean the  
inside of the boiler, you simply have to proceed as  
follows every three months:  
Fill the boiler with tap water, shake and empty. Re-  
peat these steps two or three times consecutively.  
To descale:  
-Unplug. Empty the content of a bag into the boiler.  
Fill with water and select the steam position.  
-Plug in. Switch the professional iron on.  
-Place the iron in the ironing position. Activate the  
steam, shake the iron softly.  
-Let the product work for 10 minutes.  
-Rinse thoroughly with water & empty completely.  
 
MW_EX_23810_BRAVISSIMO_PRO 2_IM.indd 6  
11/17/2009 12:49:22 PM  
Causes  
Breakdowns  
Solutions  
Iron thermos-  
tat control (J)  
set to the mi-  
nimum posi-  
tion "·""··".  
Set the thermostat  
control to the  
Water drips  
from the  
steam zone "···".  
holes on the  
base of the  
iron when  
turning on  
the steam  
switch (H).  
The boiler is  
too full.  
Remove some  
water.  
The boiler  
Place it on a  
is in a tilted horizontal sur-  
position.  
face.  
The iron does The switch Switch it to  
not heat and  
the LED (K)  
does not light  
up.  
“on” (A).  
Iron ther-  
Adjust the ther-  
mostat control.  
mostat con-  
trol (J) set to  
the minimum  
position.  
Faulty power Check the power  
connection. points.  
No steam co- Empty boiler. Fill the boiler  
mes out  
when pres-  
sing the  
steam switch  
(H).  
with water.  
Switches (B) Switch them  
and (A) are on.  
Leak Cap (F) not Let the boiler cool  
from the  
properly clo- and screw the cap  
sed.  
(F) to the end  
again.  
cap (F).  
Safety valve Go to an authori-  
activated.  
zed Technical  
Service.  
The boiler cap There is  
(F) does not steam re-  
Press the steam  
switch (H) to let  
unscrew easi- maining in- the steam out.  
ly.  
side the  
boiler.  
 
MW_EX_23810_BRAVISSIMO_PRO 2_IM.indd 7  
11/17/2009 12:49:22 PM  
27 Nourse  
Avenue Epping  
2
Cape Town  
P.O. Box 975 Eppindust 7475 South Africa  
Tel: +27 21 534 8114 Fax: +27 21 534 8086  
Service Centre Share Call: 086 111 5006  
w e b : w w w. c r e a t i v e h o u s e w a r e s . c o . z a  
 
MW_EX_23810_BRAVISSIMO_PRO 2_IM.indd 8  
11/17/2009 12:49:22 PM  

Kyocera All in One Printer KM C3225E User Manual
Lasko Fan 2519 User Manual
Lexmark Printer 248X User Manual
Life Fitness Elliptical Trainer 93X 0XXX 01 User Manual
Life Fitness Treadmill 90T XXXX 01 User Manual
Life Fitness Treadmill T55 0XXX 01 User Manual
Lincoln Electric Welder SVM189 B User Manual
Linksys Switch SD2005 User Manual
Magnadyne Security Camera C SDL User Manual
McIntosh Portable Speaker MSS530 User Manual